Salem Lakes, Kenosha
Salem Lakes homes mostly date to the late 1980s, which means torsion springs on wider double doors. We drive out from Kenosha, 13 miles away, to fix them.
Pricing
Salem Lakes' housing stock runs newer than a lot of the surrounding area - the typical home here went up around 1987, well past the 1976 median for the wider service area.
That matters for spring repair because by the mid-80s, builders had mostly switched from the old extension-spring-over-the-track setup to torsion springs mounted on a shaft above the door. Torsion systems cost more to fix than extension springs because the spring itself is heavier-duty and the job takes more care to do safely, but they also tend to outlast the cheaper hardware that came before them.
We don't post a flat number here because the real cost swings on door width, whether you've got one spring or two, and what shape the drums and cable are in. A single spring on a 16-foot double door is a different job than one spring on a 9-foot single, and we won't quote either sight unseen.
What we can tell you is that most Salem Lakes jobs are a straightforward torsion swap, not the older low-headroom or extension setups we see more of in the rest of the county's housing stock.
On the truck
With a cold moderate climate across the service area, steel springs here go through real temperature swings - cold mornings stiffen the coil, and that stiffness is part of what finally snaps a spring that's already near the end of its cycle count.
We stock torsion springs sized for the standard 7-foot and 8-foot residential door heights that match what went into Salem Lakes homes during their late-80s building boom, along with the shafts, cable drums, and end bearing plates that wear alongside them.
We carry both galvanized and oil-tempered springs; which one goes on your door depends on what's already there, since mixing wire types on a two-spring system is asking for an uneven lift.
What we don't stock is anything for the older low-headroom or side-mounted torsion setups that show up more in pre-1976 housing - if your house is one of the rare older builds out here, that part may need to be ordered, and we'll tell you that up front rather than make you wait at the door.
DIY or pro
A torsion spring is wound under enough tension to break a bone or worse if the winding bars slip, and that doesn't change because the house is newer or the door looks simple. We're not going to walk you through winding one yourself. What you can safely check: whether the door is a torsion-spring setup (spring sits horizontal above the door, on a metal shaft) or an older extension-spring setup (springs run along the horizontal tracks on either side), and whether a cable has come off a drum, which looks like a loose, kinked cable hanging slack. Both are useful things to tell us on the phone so we bring the right spring. Past that - don't cut a wound spring, don't loosen set screws, and don't try to lift a door with a broken spring by hand on a double-wide door; the weight on those is more than it looks like from the garage floor.
Local causes
We cover Salem Lakes from Kenosha, 13 miles out, which means a spring job here isn't a five-minute hop the way it might be for a company based in town. That's worth knowing before you call: we're honest about the drive, and we don't pretend otherwise. What we see most often in this town is springs that are original to a house built in the late 1980s finally reaching the end of their rated cycle count around now - torsion springs are rated in cycles, not years, and a 35-plus-year-old spring on a double door that opens a few times a day has usually used up its count. Because the housing here skews newer than much of the rest of the service area, we're rarely dealing with the oddball low-headroom brackets or extension-spring-over-track setups that complicate jobs in the older 1960s-70s stock nearby - Salem Lakes jobs are mostly standard torsion work, which keeps the repair itself simpler even with the drive.
Questions
Torsion springs are rated by cycle count, not age, but with typical daily use a spring from a house built in the late 1980s is often approaching or past its rated life right around now. A spring that squeaks, looks stretched, or has a visible gap in its coil is close to done regardless of the exact year.
Yes, though most Salem Lakes homes built around 1987 came with torsion springs rather than the older extension-spring-over-the-track setup. If your house is an older build with extension springs, tell us when you call so we bring the right parts on the truck from Kenosha.
Double doors usually run on two torsion springs working together, and if one has broken the other is usually close behind from matching wear. Replacing both at once costs more up front but avoids a second service call a few months later - we'll walk you through that trade-off rather than decide it for you.
Explore more
Ready when you are
Kenosha Garage Door Pros repairs and installs garage doors, springs and openers in Kenosha, WI and the surrounding area.
